Brake lines all finished and on a roll so started on some fuel lines. I'm using the TCW bulkhead connections at the fuselage exit so that I can use filters at the wing roots. This means that the fuel line between the tunnel and the fuse side is a straight shot with hard points at each end. Decided to bend a little chicane in the line to relieve some stress and allow for installation. Bends came out good. Gives a little extra room for the transponder antenna connection too.
My andair fuel valve finally arrived but has the wrong engraving on the plate. Not a time critical issue but a little disappointing after waiting 5 months for it. I did go ahead and install nut plates on the fuel valve. Really nice quality part.